DBW Bosch Throttle Body (e-throttle) Wiring Sub Harness

DBW Throttle Body (e-throttle) Wiring Sub Harness to connect your ECU to your Bosch  44mm / 54mm / 60mm / 68mm / 74mm / 82mm Electronic Throttle Body. ECU pins or unterminated wire on one end and the DBW Throttle Body connector on the other.

• TE Spec 44 20 AWG wire rated to 150 degrees C - Motorsport grade wire, dual layer insulation
  
• Covered with TechFlex Insultherm or DR-25 heat shrink
• Superseal 1.0 terminals crimped with Mecal/TE Press and Mecal Applicator (£6000+ factory equipment)
• Crimped with production quality Rennsteig PEW 12 frame and die set (£430+ tool)
• You may need to splice in your own sensor supply (5V+) and sensor ground wires or these can be terminated to DTM/DT pins/sockets. Put a note in the order comments or contact me for requirements.
• ECU pins available - Superseal 1.0 (Link, Haltech, Motec, Emtron, Syvecs, DTA, ECU Master PRO) / None - Unterminated wire - leave an order note with instructions.
• Harness length of 1.2m. Custom lengths available on request. Perfectly suited for RHD EP82/EP91 Starlet's with ECU mounted in standard location.

Starlet Owners - Check out our 4E-FTE Drive By Wire Adapter here